---

Product description This Calpeda brand water pump is ideal for agricultural and industrial applications for contaminated liquids. Equipped with an induction supply in a 220V single phase, this open wheel water pump is ideal for a suction height of up to 8 metres and a flow rate of 3.6 to 15 m³/h. Use: The Calpeda open wheel single-phase water pump is ideal for agricultural and industrial applications for contaminated or emulsified liquids. Calpeda is recommended to use this water pump up to +90 °C. The ambient temperature of the place should not be over 40°C. Design: The calpeda cm open wheel centrifugal pump consists of a pump body, the throw lantern is made of cast iron, the operating pressure accepts up to 6 bar. The turbine is made of brass. The 2-pin induction motor rotates at a speed of 2900 rpm with a protection factor of IP54, class F and continuous service. Lipsotherms and capacitor are integrated with this single-phase 220 V motor. The coupling shaft between turbine and induction motor is made of stainless steel. The standard mechanical insert is made of hard carbon and ceramic and allows a good seal between pump body and induction motor. This filling can be replaced for a longer life of the water pump.; Product description This Calpeda brand water pump is ideal for agricultural and industrial applications for contaminated liquids. Equipped with an induction supply in a 220V single phase, this open wheel water pump is ideal for a suction height of up to 8 metres and a flow rate of 3.6 to 15 m³/h. Use: The Calpeda open wheel single-phase water pump is ideal for agricultural and industrial applications for contaminated or emulsified liquids. Calpeda is recommended to use this water pump up to +90 °C. The ambient temperature of the place should not be over 40°C. Design: The calpeda cm open wheel centrifugal pump consists of a pump body, the throw lantern is made of cast iron, the operating pressure accepts up to 6 bar. The turbine is made of brass. The 2-pin induction motor rotates at a speed of 2900 rpm with a protection factor of IP54, class F and continuous service. Lipsotherms and capacitor are integrated with this single-phase 220 V motor. The coupling shaft between turbine and induction motor is made of stainless steel. The standard mechanical insert is made of hard carbon and ceramic and allows a good seal between pump body and induction motor. This filling can be replaced for a longer life of the water pump.; This Calpeda brand water pump is ideal for agricultural and industrial applications for contaminated liquids. Equipped with an induction supply in a 220V single phase, this open wheel water pump is ideal for a suction height of up to 8 metres and a flow rate of 3.6 to 15 m³/h. Use: The Calpeda open wheel single-phase water pump is ideal for agricultural and industrial applications for contaminated or emulsified liquids. Calpeda is recommended to use this water pump up to +90 °C. The ambient temperature of the place should not be over 40°C. Design: The calpeda cm open wheel centrifugal pump consists of a pump body, the throw lantern is made of cast iron, the operating pressure accepts up to 6 bar. The turbine is made of brass. The 2-pin induction motor rotates at a speed of 2900 rpm with a protection factor of IP54, class F and continuous service. Lipsotherms and capacitor are integrated with this single-phase 220 V motor. The coupling shaft between turbine and induction motor is made of stainless steel. The standard mechanical insert is made of hard carbon and ceramic and allows a good seal between pump body and induction motor. This filling can be replaced for a longer life of the water pump.